Форум системных администраторов

Код: Выделить всё

default:
 set log Phase Chat LCP IPCP CCP tun command
 ident user-ppp VERSION (built COMPILATIONDATE)
# set log Phase tun command
# set ifaddr 10.0.0.1/0 10.0.0.2/0
 # Ensure that "device" references the correct serial port
 # for your modem. (cuad0 = COM1, cuad1 = COM2)
 #
 #set device /dev/cuad1

 set mru 1492
 set mtu 1492
 disable ipv6cp # отключить поддержу IPv6
 enable lqr     # Link Quality Reporting - по умолчанию выключено

# set device PPPoE:bge1
# set speed 115200
 set dial "ABORT BUSY ABORT NO\\sCARRIER TIMEOUT 5 \
#           \"\" AT OK-AT-OK ATE1Q0 OK \\dATDT\\T TIMEOUT 40 CONNECT"
 set timeout 180                        # 3 minute idle timer (the default)
 enable dns                             # request DNS info (for resolv.conf)

#papchap:
 #
 # edit the next three lines and replace the items in caps with
 # the values which have been assigned by your ISP.
 #

ktnet:
# set phone PHONE_NUM
 set device PPPoE:bge1
 set authname LOGIN
 set authkey PASS
 set ifaddr 0 0

 set dial
 set login
 set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0 0.0.0.0
 add default HISADDR                    # Add a (sticky) default route

Код: Выделить всё

saver="daemon"
sshd_enable="YES"

#network_interfaces="bge1 tun0"
ifconfig_bge1="DHCP"
ifconfig_bge0="inet 192.168.0.8  netmask 255.255.255.0"

#defaultrouter="DHCP"

hostname="mywork"

ppp_user="root"
ppp_enable="YES"
ppp_mode="ddial"
ppp_profile="ktnet"
ppp_nat="YES"

Код: Выделить всё

options NETGRAPH
options NETGRAPH_ETHER
options NETGRAPH_SOCKET
options NETGRAPH_TEE

#Queuing support (requied by PF)
options         ALTQ
options         ALTQ_CBQ
options         ALTQ_RED
options         ALTQ_RIO
options         ALTQ_HFSC
#options        ALTQ_CDNR
options         ALTQ_PRIQ
options         ALTQ_NOPCC
#options        ALTQ_DEBUG

Код: Выделить всё

net.inet.ip.forwarding=1 
net.graph.nonstandard_pppoe=1